Recently, many customers have inquired about the disassembly, cleaning and installation of the roller table of tempering furnace. In this regard, Tianxin will answer your questions:
1. How to disassemble the glass tempering furnace ceramic roller table?
Only when the tempering furnace body is cooled can the ceramic roller table of the tempering furnace be replaced. When replacing the ceramic roller table, it should be operated by at least three people (one on each side and one or two in the middle). When disassembling, first remove the screws that fix the bearings, lift the ceramic roller table of the tempering equipment together and put it on the conveyor frame of the ceramic roller table.
And then drag the ceramic roller table outward. Pay attention to the gentle action when pulling out the ceramic roller table of the tempering furnace, so as not to make the roller table collide or scratch.
2. How to clean the ceramic roller table of tempering equipment?
Use a vacuum cleaner to clean the dust on the surface of the ceramic roller table of the tempering furnace, and then use a clean, hairless and soft white cloth to moisten the softened water and wipe it from the middle to both sides to clean up the dust. It is better to use distilled water or pure water to wipe the ceramic roller table of tempering equipment, and do not use alkaline cleaners or chemicals.
3. What should I pay attention to when installing the ceramic roller table of tempering furnace?
When installing the ceramic roller table of the tempering equipment, first place the ceramic roller table conveying frame of the tempering furnace near the position to be installed. At least three people will lift one end of the ceramic roller table on the roller table conveying frame and slowly push it into the tempering furnace, and then install the bearing and pulley.
At least three people (one on each side and one or two in the middle) will lift the ceramic roller table from the conveying frame, align the bearing with the bearing hole on the roller table seat plate and slowly put it in. Manually check the rotation of the ceramic roller table to ensure its flexibility and stability. Tighten the screw for fixing the bearing; Pay special attention to the fact that the top thread of the bearing at the rear end of the ceramic roller table cannot be crushed to death with the bottom of the keyway, but it should be locked with the bearing thread hole.
